Contrex M-Traverse Manuel d'utilisateur télécharger pdf (Page 151)

5 - 4

Return, Home Seek, Home Set, Batch Reset, and Setpoint

Select).

Control Mask See Appendix C; CP-73.

Control Mode See Appendix C; CP-14.

Control Parameters Control Parameters allow you to enter data that is unique

to your system (e.g., encoder resolution, Lead to Follower

ratios) and modify the M–Traverse for your specific needs

(e.g., maximum RPMs, setpoints, acceleration/deceleration

ramp rates). There are Control Parameters for Direct

mode, the Follower mode, Jog, Tuning, and Output Con-

trol. The M–Traverse comes factory pre-loaded with a

complete set of default Control Parameters.

Control State See Appendix C; MV-52.

Communications Error See Appendix C; MV-74.

DAC Output See Appendix C; MV-47.

Data Inquiry Use the Data Inquiry to request the current value for

Parameters (i.e., Control Parameters or Monitor Variables)

in serial communications.

Dedicated Keys The “Setpoint ” , “Tach” , “Batch Count” and “Status” keys

are shortcut keys that access the active Setpoint , Tach,

Batch Count and Status variables directly, rather than

manually entering the Code Parameter.

Device Address See Appendix C; CP-70.

Digital Motor Controller A precision motor controller that uses digital compensation

technology.

Direct Analog Command See Appendix C; CP-62.

Direct Mode In the Direct mode of operation, the analog output from the

M-Traverse that is connected to the motor drive can be set

directly. Direct mode is an open-loop mode of operation.

Scaling, Acceleration/Deceleration, and Closed Loop

Compensation (PI) software are not involved in the Direct

mode. The Direct mode is used in conjunction with the

Run and F-Stop controls

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 201 202

Pas de commentaire

Contrex M-Traverse Manuel d'utilisateur Page 151