Contrex CX-1010 Manuel d'utilisateur télécharger pdf (Page 34)

Page 32

13) Reinsert the CPU Board into the CX-1010 unit by aligning the CPU board with the top and

bottom card edge connectors and gently push the board straight back until the CPU board card

edge connector tab seats fully into the internal backplane card-edge connector.

14) Replace the back plate, making sure that it seats properly and the connectors are all properly

aligned in their slots.

15) Screw the back plate into place with the four machine screws.

16) Screw the ground screw back into place snugly. Replace the connectors. Replace the power

connector.

NOTE: Be sure to follow the calibration procedure before engaging the CX-1010. Refer to

CX-1010 Technical Reference Manual, Drive Setup / Calibration: Calibration.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 53 54

Pas de commentaire

Contrex CX-1010 Manuel d'utilisateur Page 34