Contrex M-Traverse Manuel d'utilisateur télécharger pdf

M-TRAVERSE INSTALLATION/START-UP GUIDE

CAUTION

Hazardous Voltages. Can cause severe injury, death or damage to

equipment. The M-Traverse should only be installed by a qualified

electrician.

Proper earth grounding of all electronic equipment is required for

successful operation. Connect a low impedance earth ground to

terminal 1 of connector J2.

Separate all logic and signal level wiring (J1, J3, and J4) from all

AC power wiring (J2).

Shield all logic and signal wiring (J1, J3 and J4) and terminate to

earth ground at one point only.

TYPICAL WIRING

*1 Encoder and Proximity Switches may require power connections from J3 pins 1 or 2.

*2 J1 pin 8 connection is not required for drives with differential inputs. Refer to User Manual Page 2-4 for jumper

requirements using 2 wire drive connections.

ONTREX, INC.ONTREX, INC.

ONTREX, INC.

SK1457 Rev 1SK1457 Rev 1

SK1457 Rev 1 Page 1

1 2 3 4

Résumé du contenu

Page 1 - TYPICAL WIRING

M-TRAVERSE INSTALLATION/START-UP GUIDECAUTIONHazardous Voltages. Can cause severe injury, death or damage toequipment. The M-Traverse should only be

Page 2 - PROGRAMMING

MOTOR DRIVE SET-UPIn order to provide for proper closed-loop operation, it is necessary to calibrate the motor drive maximum speed andresponse adjustm

Page 3

CP-15 Engineering UnitsCP-15 is your Engineering Unit measurement of a laypitch. Place the decimal in the location of your desired resolution(to the t

Page 4

CP-9 Accel/Decel LengthThe Accel/Decel Length (CP-9) parameter allows the Follower mechanism to ramp to either the constant pitch plateauor end dwell,