Contrex ML-Drive Manuel d'utilisateur télécharger pdf (Page 88)

3 - 54

Character 4 - Message Type:

This character should always be “3”.

Character 5, 6 - Parameter Number:

These characters identify the Control Parameter that you want to change

(i.e., “16” = CP-16).

Characters 7 through 10 - DATA:

These characters transmit the new value for a Control Parameter that you want to

change. The Data must be within the range specified in Appendix D.

Character 11 - Data Format:

Character 11 indicates the decimal location and polarity of the data that was

transmitted in characters 7 through 10. Use the following codes to indicate decimal

location and polarity:

Code Format

0 +XXXX

1 +XXX.X

2 +XX.XX

3 +X.XXX

4 -XXXX

5 -XXX.X

6-XX.XX

7 -X.XXX

8 +XX.XX.

Codes “0 ” through “7” are valid for CP-20 and CP-21. All other Code Parameters

have either fixed or derived decimal locations and must use Code “0”. Code “8”

does not apply to the parameter send.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 177 178

Pas de commentaire

Contrex ML-Drive Manuel d'utilisateur Page 88