Contrex ML-TRIM Manuel d'utilisateur Page 1

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Capteurs Contrex ML-TRIM. CONTREX ML-TRIM User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
ML-TRIM INSTALLATION/START-UP GUIDE
CAUTION
Hazardous Voltages. Can cause severe injury, death or damage to
equipment. The ML-Trim should only be installed by a qualified
electrician.
Proper earth grounding of all electronic equipment is required for
successful operation. Connect a low impedance earth ground to
terminal 3 of connector J3.
Separate all logic and signal level wiring (J1, J2, J4 and J5) from all
AC power wiring (J3).
Shield all logic and signal wiring (J1, J2, J4 and J5) and terminate to
earth ground at one point only.
REQUIRED WIRING
CC
CC
C
ONTREX, INC.ONTREX, INC.
ONTREX, INC.ONTREX, INC.
ONTREX, INC.
SK1451 Rev 3SK1451 Rev 3
SK1451 Rev 3SK1451 Rev 3
SK1451 Rev 3
Page 1
Vue de la page 0
1 2 3 4

Résumé du contenu

Page 1 - REQUIRED WIRING

ML-TRIM INSTALLATION/START-UP GUIDECAUTIONHazardous Voltages. Can cause severe injury, death or damage toequipment. The ML-Trim should only be instal

Page 2

SCALINGAfter completing the required wiring of the ML-Trim, follow the procedure below to scale the ML-Trim and motordrive for Master format RPM opera

Page 3 - TROUBLE-SHOOTING

FOLLOWER OPERATIONComplete the “Scaling” and “Tuning” procedures for Master mode (Page 2) before proceeding with Follower operation. To enable Follow

Page 4

Step 4: Check MP-47 (Speed Command Out).a) Should not be “0” or “100”.b) If “0”, then return to step 1 of “Scaling”.c) If “100”, check wiring to d

Modèles reliés M-Trim

Commentaires sur ces manuels

Pas de commentaire