Contrex MLP-Drive Manuel d'utilisateur télécharger pdf

MLP-DRIVE INSTALLATION/START-UP GUIDE

CAUTION

Hazardous Voltages. Can cause severe injury, death or damage to

equipment. The MLP-Drive should only be installed by a qualified

electrician.

Proper earth grounding of all electronic equipment is required for

successful operation. Connect a low impedance earth ground to

terminal 5 of connector J3.

Separate all logic and signal level wiring (J1, J2, J4 and J5) from all

motor armature and AC power wiring (J3).

Shield all logic and signal wiring (J1, J2, J4 and J5) and terminate to

earth ground at one point only.

REQUIRED WIRING

ONTREX, INC.ONTREX, INC.

ONTREX, INC.

SK1455 Rev 2SK1455 Rev 2

SK1455 Rev 2

Page 1

1 2 3 4

MLP-DRIVE INSTALLATION/START-UP GUIDECAUTIONHazardous Voltages. Can cause severe injury, death or damage toequipment. The MLP-Drive should only be in

Page 2

SCALINGAfter completing the required wiring of the MLP-Drive, follow the procedure below to scale the MLP-Drive for Masterformat RPM operation. Compl

FOLLOWER OPERATIONComplete the “Scaling” and “Tuning” procedures for Master mode (Page 2) before proceeding with Follower operation. To enable Follow

Page 4

Step 4: Check MP-47 (Drive Output).a) Should not be “0” or “100”.b) If “0”, then return to step 1 of “Scaling”.c) If “100”, check wiring to drive

Plus de documents pour Capteurs Contrex MLP-Drive

Pas de commentaire